 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-302-20-2
REAR ANTI-LOCK BRAKE SYSTEM (ABS) SENSOR REPLACEMENT - CONTINUED
0123 00
REMOVAL - CONTINUED
12
1
13
14
INSTALLATION
WARNING
Brakeshoe linings and inside drum friction surface must be free of all oil/grease and other contaminants
prior to assembly to ensure maximum braking capability. Oil/grease and other contaminants may compro-
mise braking that could lead to a serious accident resulting in injury and/or death.
NOTE
Ensure that wire loom is installed around ABS sensor cable.
1.
Position ABS sensor (13) and feed ABS sensor cable (1) through brake spider (12).
2.
Lightly coat outside of ABS sensor (13) with grease.
3.
Carefully install ABS sensor (13) on mounting bracket (14) until sensor is stopped by ABS tone ring.
4.
Install drum (11) on axle (10).
5.
At other end of ABS sensor cable (1), connect ABS sensor connector (9) to wiring harness connector (7).
6.
Install clamp (8) over ABS sensor connector (9) and wiring harness connector (7).
0123 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals