 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-302-20-2
FRONT ANTI-LOCK BRAKE SYSTEM (ABS) SENSOR REPLACEMENT - CONTINUED
0122 00
INSTALLATION (M915A3)
WARNING
Brakeshoe linings and inside drum friction surface must be free of all oil/grease and other contaminants
prior to assembly to ensure maximum braking capability. Oil/grease and other contaminants may compro-
mise braking that could lead to a serious accident resulting in injury and/or death.
1.
Install new bushing (6) to steering knuckle (7).
2.
Lightly coat outside of ABS sensor (8) with grease.
3.
Carefully push body of ABS sensor (8) on steering knuckle (7) until sensor is stopped by ABS tone ring.
NOTE
Ensure that wire loom is installed around ABS sensor cable.
4.
At other end of ABS sensor cable (2), connect ABS sensor connector (5) to wiring harness connector (3).
5.
Install clamp (4) over ABS sensor connector (5) and wiring harness connector (3).
6.
Along routing of ABS sensor cable (2), install new tiedown straps (1) to secure cable in position.
1
2
0122 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals