ADJUSTMENT - CONTINUED - TM-9-2320-302-20-20326

TM 9-2320-302-20-2

HEADLAMP ADJUSTMENT - CONTINUED

0096 00

ADJUSTMENT - CONTINUED

Back vehicle in a STRAIGHT line away from wall until vehicle is 25 ft (7.63 m) from wall. Park vehicle.

Extend mark on wall upward and downward to floor. Ensure that line is vertical. This is vehicle centerline.

On vehicle centerline, measure upward 41 in (104.1 cm) from floor. Make a horizontal line parallel to floor.

Determine low-beam headlight center by measuring outward 36.5 in (92.7 cm) on each side of vehicle centerline. Mark

center.

Measure 4 in (10.2 cm) in all four directions from mark to make an 8 in (20.3 cm) square.

10.

Repeat step 9 on other side of vehicle centerline.

11.

Determine high-beam headlamp center by measuring inward 7.5 in (19.1 cm) on each side of vehicle center line. Mark

center.

NOTE

Low-beam and high-beam squares will overlap slightly.

12.

Measure 4 in (10.2 cm) in all four directions from each mark to make two more 8 in (20.3 cm) squares.

0096 00-2