INSTALLATION - CONTINUED - TM-9-2320-302-20-20264

TM 9-2320-302-20-2

UPPER RIGHT DASH PANEL REPLACEMENT - CONTINUED

0076 00

INSTALLATION - CONTINUED

WARNING

Adhesives and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and

clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated area. If adhesive or

sealing compound contacts skin or clothing, wash immediately with soap and water.

NOTE

Two control valves are installed the same way. One control valve is illustrated. Perform steps 5 and 6

for all control valves.

Apply pipe sealing compound to threads of all fittings before installation.

Install tee (20), two elbows (21), and sending unit (23) on control valve (19).

Install control valve (19) and guard (15) on panel (7) with two screws (16).

Install two tubes (22). Install connector (24) on sending unit (23).

Install three label holders (18) on panel (7).

Install two switches (26) on panel (7) with two nuts (17).

10.

Install three fiber optic labels (25) on panel (7).

11.

Install two connectors (27) on switches (26).

12.

If removed, install three washers (6), knobs (5), and screws (4) on light switch (2).

13.

Install light switch (2) on panel (7) with four screws (11).

14.

Install connector (1) on light switch (2).

NOTE

Perform steps 15 through 17 on M915A3 New Model, M916A3, and M917A2.

15.

Install cap assembly (12) on panel (7).

16.

Install 12V power receptacle (13) in cap assembly (12).

17.

Connect connector (31) to 12V power receptacle (13).

NOTE

Perform steps 18 and 19 on M916A3 and M917A2.

18.

Install PTO switch (10) on panel (7). Ensure tangs on switch snap into place on panel.

19.

Connect connector (3) to PTO switch (10).

20.

Position panel (7) on dash and install five screws (8).

0076 00-4