 |
|||
|
|
|||
|
Page Title:
OIL FILLER HOLE COVER AND GASKET INSTALLATION - CONTINUED |
|
||
| ||||||||||
|
|
 TM 9-2320-302-20-2
ENGINE OIL FILL TUBE MAINTENANCE - CONTINUED
0024 00
OIL FILLER HOLE COVER AND GASKET INSTALLATION - CONTINUED
1.
Install new gasket (16) and oil filler hole cover (15) on engine block (17) with four screws (14). Torque screws to 22-
28 lb-ft (30-38 Nm).
WARNING
Adhesives and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated area. If adhesive or
sealing compound contacts skin or clothing, wash immediately with soap and water.
2.
Lightly coat threads of pipe nipple (13) with pipe sealing compound. Install pipe nipple and pipe coupling (12) on oil
filler hole cover (15).
OIL FILL TUBE INSTALLATION
NOTE
Perform step 1 only if standoff bracket was removed.
1.
Install standoff bracket (4) on engine block (17) with washer (7) and screw (8).
2.
Position two hose clamps (10) and hose (11) on pipe coupling (12). Tighten lower hose clamp.
3.
Position upper hose clamp (10) on filler tube (3) and install filler tube on hose (11). Tighten upper hose clamp.
4.
Install clamp (9) on standoff bracket (4) and secure in place with screw (18), two washers (5) and new locknut (6).
OIL FILL TUBE CAP INSTALLATION
1.
Install oil fill tube cap (2) on oil fill tube (3).
2.
Secure oil fill tube cap (2) retaining chain on oil fill tube (3) with screw (1).
END OF WORK PACKAGE
0024 00-3/(-4 Blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals