 |
|||
|
|
|||
|
Page Title:
ZEROING THE TS-352 B/U MULTIMETER |
|
||
| ||||||||||
|
|
 TM 5-2420-224-20-1
ZEROING THE TS-352 B/U MULTIMETER
NOTE
For accurate readings, do not
t o u c h probe ends with fingers
while zeroing the multimeter.
1.
Using adjusting screw (1), set needle (2) to
infinity
prior to OHMS ZERO ADJ.
2.
Set RANGE switch (3) to RX100.
Plug black (-) lead (4) in OHMS DC jack.
3.
4.
Plug red (+) lead (5) in upper left OHMS jack.
5.
Set FUNCTION switch (6) to OHMS.
Hold two probe tips (7) firmly together.
6.
NOTE
If needle will not zero, replace
batteries in multimeter. If needle
still will not zero, have multimeter
repaired.
7.
Zero multimeter by turning OHMS ADJ knob
(8) until needle (2) is over 0 on OHMS scale.
3-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals