Slave Starting the Engine.

TM 5-2420-224-10

(3) Set throttle lever (5) to idle position (700-750 rpm).

(4) Fully depress clutch pedal (6) to activate neutral safety switch.

(5) Insert key into ignition switch (7) and switch ON.

CAUTION

Do not crank engine for more than 30 seconds. Allow starter to cool for 2 minutes before

cranking again. Failure to do so could result in equipment damage.

(6) Press starter switch button (8) and release when engine starts.

(7) Observe oil pressure indicator (9). Do not rev engine as long as no oil pressure is indicated. If minimum oil

pressure of 9 psi (0.6 bar) is not reached after 10 seconds, immediately stop engine and notify unit

maintenance.

d. Slave Starting the Engine.

(1) The starting receptacle (1) accepts booster cables with a mating (NATO) plug. Use a battery cart or another

vehicle as a power source of 24 volts.

(2) Make sure electrolyte in batteries is filled to level of split ring. If low, notify unit maintenance.

2-76