Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: CLEANING AND INSPECTION
Back | Up | Next

Click here for a printed version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

TM 5-2420-222-34 15-6. LOADER SIDE FRAMES MAINTENANCE (Con’t).   c. CLEANING AND INSPECTION WARNING Dry  cleaning  solvent,  P-D-680,  is  toxic  and  flammable.    Always  wear  protective goggles  and  gloves,  and  use  only  in  a  well-ventilated  area.    Avoid  contact  with skin, eyes, and clothes, and DO NOT breathe vapors.  DO NOT use near open flame or  excessive  heat.  The  solvent's  flash  point  is  100°F-138°F  (38°C-59°C).    If  you become dizzy while using cleaning solvent, immediately get fresh air and medical help.  If solvent contacts eyes, immediately wash your eyes and get medical aid. 1. Clean side frame and all other metal parts with dry cleaning solvent and rags.  Dry thoroughly with clean, dry rags. 2. Inspect side frame and all other metal parts for cracks, breaks, abnormal bends, and damaged threads.   d. REPAIR 1. Restore damaged side frame (3) threads using screw threading set. 2. If cracks, breaks, or broken welds were found, repair by welding (see TM 9-237).   e. ASSEMBLY If damaged, install identification and name plates (see TM 5-2420-222-20).   f. INSTALLATION WARNING Use extreme caution when handling heavy parts.  Lifting device Is required when parts weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two person lift, and over 150 lb (68 kg) for a three or more person lift.  Keep clear of heavy parts  supported  only  by  lifting  device.    Failure  to  follow  this  warning  may cause serious Injury or death to personnel. 1. Using hydraulic floor jack, raise rear axle housing (1) off jackstand, then remove jackstand. 2. Using lifting device, lift side frame (3) into position under rear axle housing (1) and support. 3. Using hydraulic floor jack, lower rear axle housing (1) onto side frame (3). 4. Remove lifting device from side frame (3). NOTE If Installing right side frame, skip step 5. 5. Position three hydraulic hoses (8), clamp (5), and bushing (4) in place on side frame (3) Install screw (7) and new lockwasher (6) in clamp, bushing, and side frame. 6. Remove two jackstands from under transmission (2). 15-30

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business