| |
TM 5-2420-222-34
14-23.
BACKHOE STABILIZER CYLINDER ASSEMBLIES REPAIR (Cont).
2.
Using spanner wrench, loosen nut (11) from actuating cylinder (1). Slide nut back onto piston rod (10).
NOTE
Use a drain pan to catch fluid when draining actuating cylinder. Clean up all spills.
3.
Loosen vise and tilt actuating cylinder (1) to drain hydraulic fluid.
4.
Tighten vise. With the aid of an assistant, remove piston rod (10) with assembled parts from actuating cylinder
(1).
5.
Remove actuating cylinder (1) from vise.
6.
Place piston rod (10) In vise with caps. Remove self-locking nut (2) from piston rod. Discard self-locking nut.
7.
Tap pistons (4 and 7) with assembled parts loose and remove from piston rod (10). Remove piston rod from vise.
8.
Remove rod guide (16) with assembled parts, cylinder roller bearing (13), and nut (11) from piston rod (10).
9.
Remove piston ring (3) from piston (4). Discard piston ring.
TA701626
14-112
|