Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: CLEANING AND INSPECTION
Back | Up | Next

Click here for a printed version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

TM 5-2420-222-34 14-22. BACKHOE SWING CYLINDER ASSEMBLIES REPAIR (Con’t). 15. Remove rod packing (18), wear ring (17), and seal (13) from valve stem guide (16).  Discard rod packing, wear ring, and seal. 16. Remove two lubrication fittings (10) from actuating cylinder (5). 17. Remove lubrication fitting (10) from piston rod (11). CAUTION Do not remove sleeve bushings unless damaged.  Removal may damage parts. 18. Drive sleeve bushing (12 or 25) out of piston rod (11) or actuating cylinder (5). b. CLEANING AND INSPECTION WARNING Dry cleaning solvent, P-D-680, is toxic and flammable.  Always wear protective goggles and gloves, and use only In a well-ventilated area.  Avoid contact with skin, eyes, and clothes, and DO NOT breathe vapors.  DO NOT use near open flame or excessive heat.  The solvent's flash point is 100F-138°F (38°C-59C). If you become dizzy while using cleaning solvent, Immediately get fresh air and medical  help.    If  solvent  contacts  eyes,  Immediately  wash  your  eyes  and  get medical aid. Compressed   air   used   for   cleaning   or   drying   purposes,   or   for   clearing restrictions,  should  never  exceed  30  psi  (207  kPa).    Wear  protective  clothing (goggles/shield, gloves, etc.  ) and use caution to avoid injury to personnel. 1. Clean all metal parts with rags dampened with dry cleaning solvent.  Dry thoroughly with compressed air. 2. Inspect actuating cylinder for cracks, breaks, chips, and excessive scoring inside actuating cylinder. 3. Inspect piston rod for cracks, breaks, and excessive scoring. 4. Inspect sleeve bushings for cracks, breaks, and excessive scoring. 5. Inspect all metal parts for cracks, breaks, and abnormal bends. 6. Inspect all threaded parts for damaged threads. c. REPAIR 1. Remove any minor scoring from actuating cylinder (5) or piston rod (11) using 600 grit abrasive cloth. 2. Restore damaged threads using pipe threading or screw threading set. d. ASSEMBLY NOTE Perform step 1 only if sleeve bushings were removed. 1. Drive sleeve bushing (12 or 25) in piston rod (11) or actuating cylinder (5). 14-108

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business