Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: BACKHOE CROWD CYLINDER ASSEMBLY REPAIR
Back | Up | Next

Click here for a printed version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

TM 5-2420-222-34 14-19. BACKHOE CROWD CYLINDER ASSEMBLY REPAIR. This Task Covers: a. Disassembly c. Repair b. Cleaning and Inspection d. Assembly Initial Setup: Equipment Conditions: Materials/Parts: Backhoe crowd cylinder assembly removed (see Abrasive cloth (Item 6, Appendix B) TM 5-2420-222-20). Hydraulic fluid (Item 15, Appendix B) Rags (Item 28, Appendix B) Dry cleaning solvent (Item 31, Appendix B) Tools/Test Equipment: General mechanic's tool kit Two preformed packings (serial numbers 319995-342573) Field automotive shop set Two self-locking nuts (serial numbers 235786- General Safety Instructions: 235999) Dry cleaning solvent is flammable and must not be Two V-packings used near open flame.  Use only in a well-ventilated Two wear rings area. Eight preformed packings (serial numbers 235786-235999) Compressed air used for cleaning purposes should never exceed 30 psi (207 kPa). Personnel Required: Two   a. DISASSEMBLY NOTE Steps 1 through 3 apply only to loader backhoes with serial numbers 235786- 235999. 1. Remove two self-locking nuts (6), ferrules (5), preformed packings (3), and packing retainers (4) from adapters (2).  Discard self-locking nuts and preformed packings. 2. Remove two adapters (2) and preformed packings (1) from actuating cylinder (29).  Discard preformed packings. 3. Remove two tubes and fittings (7) and preformed packings (8) from actuating cylinder (29).  Discard preformed packings. 4. Place actuating cylinder (29) in vise with caps. 5. Remove lubrication fitting (27) and setscrew (9) from actuating cylinder (29). 6. Using spanner wrench, loosen valve stem guide (21) from actuating cylinder (29).  Slide valve stem guide back onto piston rod (19). NOTE Use a drain pan to catch fluid when draining actuating cylinder.  Clean up all spills. 7. Loosen vise and tilt actuating cylinder (29) to drain hydraulic fluid. 8. Tighten vise.  With the aid of an assistant, remove piston rod (19) with assembled parts from actuating cylinder (29). 14-88

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business