|
| |
TM5-2420-222-34
13-3.
CANOPY PROTECTIVE ROOF MAINTENANCE (SERIAL NUMBERS 319995- 342573).
This Task Covers:
a.
Removal
d.
Assembly
b.
Disassembly
e.
Installation
c.
Cleaning and Inspection
Initial Setup:
Tools/Test Equipment:
Materials/Parts:
•
General mechanic's tool kit
•
Detergent (Item 13, Appendix B)
•
Field automotive shop set
•
Rags (Item 28, Appendix B)
General Safety Instructions:
•
Dry cleaning solvent (Item 31, Appendix B)
•
Dry cleaning solvent is flammable and must not be
used near open flame. Use only in a well-
Personnel Required: Two
ventilated.
a.
REMOVAL
WARNING
Use extreme caution when handling heavy parts. Lifting device is required when
parts weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two
person lift, and over 150 lb (68 kg) for a three or more person lift. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may
cause serious Injury or death to personnel.
1.
Using lifting device, support canopy panel (1).
2.
Remove four nuts (8), bolts (5), sleeve spacers (7), and 12 washers (6) from canopy (9) and canopy panel (1).
3.
Remove four drive screws (3) and washers (2) from canopy panel (1) and canopy (9).
4.
Using lifting device, remove canopy panel (1) from canopy (9) and set on wood blocks.
b.
DISASSEMBLY
Remove two channels (4) from front and rear edge of canopy panel (1).
c.
CLEANING AND INSPECTION
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective
goggles and gloves, and use only in a well-ventilated area. Avoid contact with
skin, eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame
or excessive heat. The solvent's flash point is 100°F-138°F (38°C-59°C). If you
become dizzy while using cleaning solvent, immediately get fresh air and medical
help. If solvent contacts eyes, Immediately wash your eyes and get medical aid.
1.
Clean canopy panel and all other metal parts with dry cleaning solvent and rags. Dry thoroughly with clean, dry rags.
13-10
|
