|
| |
TM 5-2420-222-34
3-3.
ENGINE ASSEMBLY REPLACEMENT (Con’t).
NOTE
Steps 2 and 3 apply only to loader backhoes with serial numbers 235786-235999.
2.
Remove solenoid lead terminal (6) from engine starting aid fluid injection solenoid terminals (5 and 7).
3.
Remove two screws (14), washers (13), lockwashers (11), washers (10), nuts (12), engine starting aid fluid injection
solenoid (8), backet (15), and ground terminal (4) from solenoid bracket (9) and terminal (16). Discard lockwashers.
4.
Remove cotter pin (21) and washer (20) from speed control rod (18). Remove speed control rod from shaft (19).
Discard cotter pin.
5.
Using adhesive tape, secure speed control rod (18) to engine block (22).
6.
Remove self-locking nut (25) and wiring harness terminal (26) from fuel injection pump shutoff solenoid terminal (17).
Discard self-locking nut.
7.
Remove tie-down bands (23) from main wiring harness fuel shutoff lead (24). Discard bands.
8.
Remove main wiring harness fuel shutoff lead (24) from engine block (22).
TA701223
3-8
|
