|
| |
TM 5-2420-222-34
10-2.
PARKING BRAKE LINKAGE MAINTENANCE (Con’t).
d.
REPAIR
Restore damaged remote control lever (15) threads using screw threading set.
e.
ASSEMBLY
1.
Aline match-marks and install support arm (4) on shouldered shaft (6). Drive new spring pin (12) in support arm
and shouldered shaft.
NOTE
Brake band arm Is used on loader backhoes with serial numbers 319995-342573.
Brake bellcrank Is used on loader backhoes with serial numbers 235786-235999.
2.
Install connecting link (16), straight pin (18), and new cotter pin (23) in brake band arm (20) or brake bellcrank
(21).
NOTE
Step 3 applies only to loader backhoes with serial numbers 235786-235999.
3.
Install shouldered pin (19) in brake bellcrank (21).
f.
INSTALLATION
1.
Install grooved pin (25) in anchor band (22).
2.
Position anchor band (22) and assembled grooved pin (25) in transmission (26). Hold anchor band and install
grooved pin (27) in transmission.
3.
Install new cotter pin (29) in grooved pin (27).
4.
Install pipe plug (28) in transmission (26).
NOTE
Brake band arm Is used on loader backhoes with serial numbers 319995-342573.
Brake bellcrank Is used on loader backhoes with serial numbers 235786-235999.
5.
Install brake bellcrank (21) or brake band arm (20) with assembled parts in place in anchor band (22).
NOTE
If brake shouldered shaft was not removed, skip steps 6 through 16.
6.
Install new preformed packing (10) in place on shouldered shaft (6).
7.
Slide shouldered shaft (6) partway in transmission (26) and install remote control lever (15) on shouldered shaft.
8.
Install woodruff key (11) in shouldered shaft (6).
9.
Aline keyway In remote control lever (15) with woodruff key (11) in shouldered shaft (6). Slide remote control lever
In place on woodruff key.
10-10
|
