|
| |
TM 5-2420-222-34
9-3.
REAR AXLE HOUSING, SHAFTS, SEALS, BEARINGS, AND PLANETARY PINION CARRIER MAINTENANCE
(Con’t).
NOTE
Steps 8 through 12 apply only to right side rear axle housing.
8.
Aline match-marks and Install brake disk (8) on final drive shaft (7).
9.
Aline splines and install final drive shaft (7) and assembled brake disk (8) in drive shaft hub and transmission (9).
10. Using lifting device, raise and aline rear axle housing (1) with final drive shaft (7); aline three straight pins (44) with
holes in transmission (9).
11. Install rear axle housing (1) with assembled parts and new gasket (6) on transmission (9). Turn axle shaft (15) as
required to mesh final drive shaft (7) in rear axle housing.
12. Install, but do not tighten, eight screws (10) in rear axle housing (1) and transmission (9).
13. Remove wood blocks from under transmission (9).
TA701454
9-28
|
