|
| |
TM 5-2420-222-34
9-3.
REAR AXLE HOUSING, SHAFTS, SEALS, BEARINGS, AND PLANETARY PINION CARRIER MAINTENANCE
(Con’t).
NOTE
Steps 11 through 17 apply only to left side rear axle housing.
11. Using lifting device, support rear axle housing (1).
12. Place drain pan under rear axle housing (1).
13. Remove twelve screws (10) from rear axle housing (1) and transmission (9).
14. Using lifting device, remove rear axle housing (1) with assembled parts and gasket (6) from transmission (9) and final
drive shaft (7) and set on wood blocks. Discard gasket.
15. Remove final drive shaft (7) and assembled brake disk (8) from collar (11) and transmission (9).
16. Using center punch and ball-peen hammer, match-mark brake disk (8) and final drive shaft (7).
17. Remove brake disk (8) from final drive shaft (7).
18. Pry with two pry bars on opposite sides of brake
pressure plate (12) at several positions until loose.
Remove brake pressure plate and assembled parts
from rear axle housing (1).
19. Remove two preformed packings (13 and 14) from
brake pressure plate (12). Discard preformed
packings.
TA701441
9-14
|
