|
| |
TM 5-2420-222-34
8-6.
DIFFERENTIAL DRIVE SHAFT ASSEMBLY MAINTENANCE (Con’t).
3.
Subtract reading In step 1 from reading in step 2. The result is the total thickness of shims (5) to be placed on
drive shaft (20) between bearing cup (4) and first and fifth speed gear (7).
4.
Using installer and ball-peen hammer, install bearing cups (4 and 18) in transmission (21).
5.
Install shims (5), sleeve spacer (6), third and seventh speed gear (16), fourth and eighth speed gear (14), second
and sixth speed gear (11), first and fifth speed gear (7), two shaft collars (9), two shifter collar sleeves (8), four
thrust washer bearings (10, 12, 13, and 15), shims or ring spacers (17), bearing cone (19), and drive shaft (20) in
two bearing cups (4 and 18).
6.
Position bearing cone (3) in place on drive shaft (20) and bearing cup (4).
TA701376
8-32
|
