|
| |
TM 5-2420-222-34
7-1.
ENGINE AC GENERATOR REPAIR (Con’t).
7.
Position stator (14) in place on two semiconductor devices (13 and 17).
CAUTION
Do not twist or bend terminals. Twisting or bending terminals may damage parts.
Use long round nose pliers as a heat sink to prevent damage to semiconductor
devices while soldering stator lead terminals.
NOTE
If stator lead terminals have not been unsoldered, skip steps 8 and 9. All six stator
lead terminals are soldered the same way. One stator lead terminal and
semiconductor device Is shown. Repeat steps 8 and 9 for remaining connections.
8.
Using soldering gun and long round nose pliers, solder stator lead terminal (16) and diode (12) on semiconductor
device (13). Allow solder connection to cool.
WARNING
Insulating varnish Is toxic and flammable. Boiling point is 230F (110C). Wear
protective goggles and gloves, and use only in areas with forced ventilation. Avoid
contact with skin, eyes, and clothes, and do not breathe vapors. Do not use near
open flame or excessive heat. If you become dizzy while using Insulating varnish,
get fresh air Immediately and get medical aid. If contact with eyes is made, wash
your eyes with water and get medical aid immediately. If swallowed, do not induce
vomiting and get medical aid Immediately.
9.
Use a paint brush to apply insulating varnish to solder connection between stator lead terminal (16) and diode
(12).
TA701340
7-10
|
