|
| |
TM 5-2420-222-34
4-3.
CLUTCH MANUAL CONTROL LEVER REPLACEMENT. (Con’t)
WARNING
Parts of clutch assembly will be coated with asbestos dust. Breathing this dust
may be hazardous to your health. Use a filter mask approved for use against
asbestos dust. Never use compressed air or a dry brush to clean these
assemblies. Dust shall be removed using an Industrial-type vacuum cleaner
equipped with a high efficiency filter system.
a.
REMOVAL
1.
Note position of spring (4) on spring pin (3) and reverser housing (1) to ensure proper Installation. Drive spring pin
out of manual control lever. Discard spring pin.
2.
Hold spring (4) and remove manual control lever (2) from reverser housing (1) and clutch bushing (5).
CAUTION
Do not remove clutch bushing unless damaged. Removal may damage parts.
3.
Using brass drift and hammer, drive clutch bushing (5) out of reverser housing (1).
TA701314
4-16
|
