|
| |
TM 5-2420-222-34
4-1.
CLUTCH ASSEMBLY MAINTENANCE (SERIAL NUMBERS 235786-235999) (Con’t).
WARNING
Parts of clutch assembly will be coated with asbestos dust. Breathing this dust
may be hazardous to your health. Use a filter mask approved for use against
asbestos dust. Never use compressed air or a dry brush to clean these
assemblies. Dust shall be removed using an industrial-type vacuum cleaner
equipped with a high efficiency filter system.
a.
REMOVAL
1.
Using machinist’s scriber, match-mark flywheel (1) and clutch disk assembly (4).
CAUTION
Clutch assembly is under strong spring tension. When removing clutch
assembly from flywheel, release spring tension slowly and evenly to avoid
damaging parts.
2.
Loosen six screws (5) one turn, then repeat until all spring tension between flywheel (1) and clutch disk assembly (4)
has been released.
3.
Remove six screws (5) and lockwashers (6) from flywheel (1) and clutch disk assembly (4). Discard lockwashers.
TA701304
4-2
|
