|
| |
TM 5-2420-222-34
3-10.
FLYWHEEL HOUSING MAINTENANCE (Con’t).
e.
INSTALLATION
1.
Using pilot and driver, install new seal (3) in flywheel housing (2).
2.
Position new gasket (4) in place on engine block (5).
WARNING
Use extreme caution when handling heavy parts. Lifting device Is required when
parts weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two
person lift, and over 150 lb (68 kg) for a three or more person lift. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may
cause serious Injury or death to personnel.
3.
With the aid of an assistant, lift flywheel housing (2) into position on engine block (5).
4
Install nine screws (1) in flywheel housing (2) and engine block (5).
FOLLOW-ON TASKS:
•
Install engine flywheel and ring gear (see paragraph 3-9).
•
Install engine oil pressure switch (see TM 5-2420-222-20).
•
Install clutch pressure plate, disk, carrier, and bearing (see paragraph 4-1 or 4-2).
•
Install engine assembly (see paragraph 3-3).
TA701262
3-66
|
