| |
TM 5-2420-222-20-3
HYDRAULIC IMPACTOR MOUNTING ADAPTER - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Some parts are heavy. Be careful when handling them. Lifting equipment is needed when parts
weigh over 50 pounds (23 kg) for a single person lift, over 100 pounds (45 kg) for a two person lift,
and over 150 pounds (68 kg) for a three or more person lift. Do not try to handle heavy parts
without lifting equipment. Keep clear of heavy parts supported only by lifting equipment. Failure
to observe this precaution could cause serious injury or death of personnel.
1.
Hydraulic
Mounting adapter (2)
Using 500-pound capacity lifting
impactor (1)
equipment, position on wood blocks
pointing up.
Keep adapter supported with lifting
equipment when on blocks to take
pressure off mounting screws.
2.
Chain (3) and
Linch pin (4)
Unlatch and pull out.
mounting adapter (2)
3.
Mounting adapter (2)
Chain (3)
Take out.
4.
Hydraulic impactor
Eight screws (5)
Using 5/8-inch, 3/4-inch drive socket-
(1) and mounting
head screw screwdriver bit and hinged
adapter (2)
handle, unscrew and take out.
5.
Hydraulic
Mounting adapter (2)
a.
Note relative position for proper
impactor (1)
placement during installation.
b.
With aid of assistant using 15 to
16-inch pry bar and 500-pound capacity
lifting equipment, lift off and set on
wood blocks.
c.
Take off 500-pound capacity lifting
equipment.
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-137).
2-1884
|