|
| |
TM 5-2420-222-20-3
BACKHOE STABILIZER CYLINDERS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION
WARNING
Some parts are heavy. Be careful when handling them. Lifting equipment is needed
when parts weigh over 50 pounds (23 kg) for a single person lift, over 100 pounds
(45 kg) for a two person lift, and over 150 pounds (68 kg) for a three or more person
lift. Do not try to handle heavy parts without lifting equipment. Keep clear of heavy
parts supported only by lifting equipment. Failure to observe this precaution could
cause serious injury or death of personnel.
24.
Stabilizer (1)
Stabilizer
Using 100-pound capacity lifting equip-
and main frame (2)
cylinder (3)
ment place into position and support.
25.
Main frame (2)
Pin (4)
a.
Aline holes in pin (4) and main
and stabilizer
frame (2).
cylinder (3)
b.
Using 3-pound head cross-peen
hammer, tap into position.
26.
Main frame (2)
Screw (5) and new
Screw together and tighten using 3/4-
and pin (4)
locknut (6)
inch, 1/2-inch drive socket, ratchet
handle, and 3/4-inch open-end wrench.
27.
Stabilizer (1)
Pin (7)
a.
Aline hole in pin (7) and stabilizer (1).
and stabilizer
b.
Using 3-pound head cross-peen
cylinder (3)
hammer, tap into position.
28.
Stabilizer (1)
Screw (8) and new
Screw together and tighten using 3/4-
and pin (7)
locknut (9)
inch, 1/2-inch drive socket, ratchet
handle, and 3/4-inch open-end wrench.
29.
Stabilizer (1)
Stabilizer
Take off 100-pound capacity lifting
and main frame (2)
cylinder (3)
equipment.
30.
Adapter (10)
Hose (11)
a.
Take off tag.
b.
Uncap.
c.
Screw in and tighten using 11/16-inch
and 7/8-inch open-end wrenches.
31.
Adapter(12)
Hose (13)
a.
Take off tag.
b.
Uncap.
c.
Screw in and tighten using 11/16-inch
and 7/8-inch open-end wrenches.
32.
Loader backhoe
Transmission
Check fluid level and add proper amount
and grade (TM 5-2420-222-10).
2-1758
|
