|
| |
TM 5-2420-222-20-3
HYDRAULIC IMPACTOR VALVE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
31.
Bracket (1) and
Two bolts (3) and
Screw together and tighten using 9/16-
valve (2)
new stop nuts (4)
inch, 3/8-inch drive deep socket, ratchet
handle, and 9/16-inch box wrench.
32.
Valve (2)
Plug and packing
Screw in and tighten using 1 1/4-inch
assembly (5)
open-end wrench.
33.
Washer (6)
Place in position.
34.
Clevis (7)
a.
Using clean rag and multiple tongue
and groove slip-joint pliers, hold
valve (2).
b.
Screw in and tighten using plier wrench.
35.
Two elbow and
Two nuts
Screw on all the way by hand.
packing assemblies
(10 and 11)
(8 and 9)
36.
Valve (2)
Two elbow and
Screw in and tighten to position noted
packing assemblies
during disassembly using 1 1/8-inch
(8 and 9)
open-end wrench.
37.
Valve (2) and two
Two nuts (10 and 11)
Using 1 1/8-inch and 1 1/4-inch open-end
elbow and packing
wrenches, tighten until seated against
assemblies (8 and 9)
valve (2).
38.
Elbow and packing
Elbow (12)
Screw on and tighten to position noted
assembly (9)
during disassembly using 1 1/4-inch
open-end wrench.
39.
Clevis (7) and
Link (13)
Place in position noted during
bracket (1)
disassembly.
40.
Clevis (7) and
Pin (14)
Place in position.
link (13)
41.
Clevis (7) and
New cotter pin (15)
a.
Place in position.
pin (14)
b.
Using multiple tongue and groove slip-
joint pliers, bend ends back.
42.
Link (13)
Pedal rod (16)
Place in position.
2-1234
|
