|
| |
TM 5-2420-222-20-3
LOADER CONTROL VALVE-TO-LOADER BOOM CYLINDER ROD END OIL LINES- CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
14.
Loader control
Tee (2) with
a.
Note relative position for proper
valve (1)
assembled parts
placement during installation.
b.
Using 1-inch open-end wrench,
unscrew and take off.
c.
Plug control valve (1) (page 2-137).
d.
Get rid of drained fluid (page 2-137).
15.
Tee (2)
Packing (3)
a.
Using pocket knife, take off.
b.
Get rid of.
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-137).
16
Hose (4)
a
Using clean rags dampened with solution
of detergent and water, wipe clean.
b
Rinse with clean water.
c
Using clean, dry rags, wipe dry.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and gloves and use
only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors.
Do not use near open flame or excessive heat. The flashpoint is 100F to 138F (38 to 59C). If
you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid. If
contact with eyes is made, wash your eyes with water and get medical aid immediately.
17.
All metal parts
a.
Clean in drycleaning solvent.
b.
Using clean, dry rags, wipe dry.
INSPECTION/REPLACEMENT
NOTE
For more information on how to inspect parts, go to General Maintenance Instructions (page 2-
137).
Replace defective parts as needed.
2-1692
|
