|
| |
TM 5-2420-222-20-3
LOADER CONTROL VALVE-TO-HYDRAULIC OIL FILTER RELIEF VALVE OIL LINE
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
11.
Hose (1)
Clamp (2)
a.
Using 1/4-inch flat-tip screwdriver,
loosen.
b.
Slide off.
12.
Connector (3)
Hose (1)
Pull off.
13.
Hydraulic oil
Connector (3) with
a.
Using 1 1/4-inch open-end wrench,
filter relief
assembled
unscrew and take out.
valve (4)
packing (5)
b.
Plug valve (4).
14.
Connector (3)
Packing (5)
a.
Using pocket knife, take off.
b.
Get rid of.
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance Instructions
(page 2-137).
15.
Hose (1)
a.
Using clean rags dampened in solution
of detergent and water, wipe clean.
b.
Rinse with clean water.
c.
Using clean, dry rags, wipe dry.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and
gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes
and don’t breathe vapors. Do not use near open flame or excessive heat. The
flashpoint is 100° to 138° (38° to 59°C). If you become dizzy while using cleaning
solvent, get fresh air immediately and get medical aid. If contact with eyes is made,
wash your eyes with water and get medical aid immediately.
16.
Oil line (6)
a.
Using clean rags dampened in drycleaning
solvent, wipe clean.
b.
Using clean, dry rags, wipe dry.
17.
All other metal
a.
Clean in drycleaning solvent.
parts
b.
Using clean, dry rags, wipe dry.
2-1656
|
