|
| |
TM 5-2420-222-20-3
JAW CYLINDER OIL HOSES - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
13.
Elbow (1)
Nut (2)
Screw on all the way.
14.
New packing (3)
Place in position.
15.
Cylinder barrel (4)
Elbow (1) with
a.
Unplug barrel (4).
assembled parts
b.
Screw in and tighten to same relative
position noted during removal using
11/16-inch open-end wrench.
16.
Cylinder barrel (4)
Nut (2)
Using two 11/16-inch open-end wrenches,
and elbow (1)
tighten until seated against barrel (4).
17.
Elbow (1)
Hose (5)
a.
Take off tag.
b.
Screw in and tighten using two 11/16-
inch open-end wrenches.
NOTE
If installing jaw cylinder rod end oil hose, skip step 18.
18.
Cylinder barrel (4)
Hose (5)
a.
Uncap barrel (4).
b.
Take off tag.
c.
Screw in and tighten using 11/16-inch
open-end wrench.
19.
Spacer (6)
Hose (5)
Wrap around using same routing noted
during removal.
20.
Tube (7)
Hose (5)
a.
Uncap tube (7).
b.
Take off tag.
c.
Screw in and tighten using 3/4-inch
and 718-inch open-end wrenches.
21.
Loader backhoe
Transmission
Check fluid level and add proper amount
and grade (TM 5-2420-222-10).
22.
Engine
Start and run at high idle
(TM 5-2420-222-10).
23.
Jaw cylinder
a.
Operate jaw controls (TM 5-2420-222-10)
oil hoses
and check for leaks.
b.
If leaking at any connection, tighten
using one or two 11116-inch, 3/4-inch
and 7/8-inch open-end wrenches.
2-1548
|
