|
| |
TM 5-2420-222-20-3
JAW CONTROL (DIRECT LINEAR) VALVE-TO-MANIFOLD BLOCK OIL LINES - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
12.
Hose (1)
Isolator (2)
Take off.
13.
Nine hoses (1 and
Band (11)
a.
Using diagonal-cutting pliers, cut off.
3 thru 10)
b.
Get rid of.
14.
Three clamps (12
Screw (17) and
a.
Using 9/16-inch, 3/8-inch drive
thru 14), spacer
lockwasher (18)
socket and ratchet handle, unscrew
(15) and boom (16)
and take out.
b.
Get rid of lockwasher (18).
15.
Two tubes (19 and
Two clamps (12 and
Take off.
20) and clamp (14)
13) and spacer (15)
16.
Tube (19)
Hose (1)
a.
Place drain pan underneath.
b.
Using 3/4-inch and 7/8-inch open-
end wrenches, unscrew and take off.
c.
Tag (page 2-137).
d.
Cap tube (19) (page 2-137).
17.
Boom (16)
Hose (1)
Noting routing, pull out.
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-137).
18.
All rubber parts
a.
Using clean rags dampened in solution
of detergent and water, wipe clean.
b.
Rinse with clean water.
c.
Using clean, dry rags, wipe dry.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and gloves and use only
in a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not
use near open flame or excessive heat. The flashpoint is 100°F to 138°F (38° to 59°C). If you become
dizzy while using cleaning solvent, get fresh air immediately and get medical aid. If contact with eyes is
made, wash your eyes with water and get medical aid immediately.
19.
All metal parts
a.
Clean in drycleaning solvent.
b.
Using clean, dry rags, wipe dry.
2-1516
|
