|
| |
TM 5-2420-222-20-3
JAW DIRECT LINEAR VALVE-TO-HYDRAULIC IMPACTOR VALVE OIL LINE (SERIAL NUMBERS 319995 THRU
342573 ONLY) - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
DISASSEMBLY
10.
Tee (1)
Pipe adapter (2)
a.
Place tee (1) in machinist’s vise.
with assembled
b.
Note relative position for proper
tee (3)
placement during assembly.
c.
Using 1 1/4-inch open-end wrench,
unscrew and take off.
11.
Elbow (4)
a.
Note relative position for proper
placement during assembly.
b.
Using two 1 1/4-inch open-end
wrenches, unscrew and take out.
c.
Take tee (1) out of machinist’s vise.
12.
Tee (3)
Pipe adapter (2)
a.
Place tee (3) in machinist’s vise.
b.
Using 1 1/4-inch open-end wrench,
unscrew and take off.
c.
Take tee (3) out of machinist’s vise.
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance
Instructions (page 2-137).
13.
Hose (5)
a.
Using clean rags dampened in solution
of detergent and water, wipe clean.
b.
Rinse with clean water.
c.
Using clean, dry rags, wipe dry.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and
gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and
clothes and don’t breathe vapors. Do not use near open flame or excessive heat.
The flashpoint is 100°F to 138°F (38° to 59°C). If you become dizzy while using
cleaning solvent, get fresh air immediately and get medical aid. If contact with
eyes is made, wash your eyes with water and get medical aid immediately.
14.
All metal parts
a.
Clean in drycleaning solvent.
b.
Using clean, dry rags, wipe dry.
2-1424
|
