|
| |
TM 5-2420-222-20-3
HYDRAULIC PUMP-TO-PRESSURE CONTROL VALVE OIL LINE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
28
Tee (1)
Hose (2)
a
Take off tag.
b
Unplug.
c
Screw on and tighten using 3/4-inch
and 7/8-inch open-end wrenches.
29.
Connector (3)
New packing (4)
Place in position.
30.
Hydraulic pump (5)
Connector (3)
Screw in and tighten using 1 3/8-inch
with assembled
open-end wrench.
packing (4)
31
Connector (3)
Elbow (6)
Screw on to same relative position noted
during removal using two 1 3/8-inch
open-end wrenches.
32
Elbow (6), clamp
Oil line (8)
a
Takeoff tag.
(7), and tee (1)
b
Place in position.
c
Screw onto elbow (6) and tighten
using 1 3/8-inch open-end wrench.
33
Two clamps (7 and
Two hose clamps (14)
Place in position.
9) and five oil
lines (8, 10, 11,
12, and 13)
34
Two hose clamps (14)
Two screws (15),
Screw together and tighten using 7/16-
washers (16), and
inch, 1/2-inch drive socket, ratchet
nuts (17)
handle, and 7/16-inch open-end wrench.
35
Tee (1)
Oil line (8)
a
Take off tag.
b
Screw on and tighten using 1 1/4-inch
and 1 3/8-inch open-end wrenches.
36
Loader backhoe
Hydraulic oil filter
Install (page 2-1698).
37.
Pressure control
Install (page 2-1647).
valve-to-loader
control valve oil
line
38.
Hydraulic oil cooler
Install (page 2-841).
39.
Air cleaner
Install (page 2-237).
Do not install right side grille
at this time.
2-1382
|
