|
| |
TM 5-2420-222-20-3
HYDRAULIC PUMP-TO-PRESSURE CONTROL VALVE OIL LINE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSPECTION/REPLACEMENT- CONTINUED
18
All metal parts
Look for cracks, breaks, and abnormal
bends.
19
All threaded parts
Look for damaged threads.
ASSEMBLY
20
Tee (1)
Oil line (2)
a
Place tee (1) in machinist’s vise.
b
Screw on and tighten to position
noted during disassembly using 1 3/8-
inch open-end wrench.
c
Take tee (1) out of machinist’s vise.
INSTALLATION
NOTE
If oil line mounting brackets and clamps were not take off during removal, skip steps 21 thru 24.
21.
Oil pan (3)
Two brackets (4)
Place in position.
22.
Two brackets (4),
Two screws (6) and
a
Screw in and tighten until snug using
oil pan (3), and
new lockwashers (7)
9/16-inch, 1/2-inch drive socket, 5-
engine block (5)
inch extension, and ratchet handle.
b
Using 9/16-inch, 1/2-inch drive
socket, 5-inch extension, and 0 to 150
foot-pound torque wrench, tighten to
50 foot-pounds (68 N•m) torque.
23
Two brackets (4)
Two clamps
Place in position.
and three oil lines
(11 and 12)
(8 thru 10)
24
Two clamps (11 and
Two screws (13), new
Screw together and tighten using 1/2-
12) and two
lockwashers (14),
inch, 1/2-inch drive socket, ratchet
brackets (4)
and nuts (15)
handle, and 1/2-inch open-end wrench.
2-1380
|
