|
| |
TM 5-2420-222-20-3
HYDRAULIC OIL COOLER-TO-CLUTCH CONTROL VALVE OIL LINE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION
NOTE
If oil line mounting brackets and clamps were not taken off during removal, skip steps 21 thru 24.
21
Oil pan (1)
Two brackets (2)
Place in position.
22
Two brackets (2),
Two screws (4) and
a.
Screw in and tighten until snug using
oil pan (1), and
new lockwashers (5)
9/16-inch, 1/2-inch drive socket, 5-
engine block (3)
inch extension, and ratchet handle.
b.
Using 9/16-inch, 1/2-inch drive
socket, 5-inch extension, and 0 to 150
foot-pound capacity torque wrench,
tighten to 50 foot-pounds (68 N•m)
torque.
23
Two brackets (2)
Two clamps (10)
Place in position.
and four oil lines
(6 thru 9)
24
Two clamps (10) and
Two screws (11), new
Screw together and tighten using 1/2-
two brackets (2)
lockwashers (12),
inch, 1/2-inch drive socket, ratchet
and nuts (13)
handle, and 1/2-inch open-end wrench.
25
Clutch control
Oil line (16) with
a.
Unplug valve (14) and oil cooler (15).
valve (14) two
assembled hose (17),
b.
Take off tag.
clamps (10), and
and two hose clamps
c.
Place in position.
oil cooler (15)
(18), and new
packing (19)
26
Two clamps (10) and
Two hose clamps (20)
Place in position.
five oil lines (6,
7, 8, 9, and 16)
27
Two hose clamps (20)
Two screws (21),
Screw together and tighten using 7/16-
washers (22), and
inch, 1/2-inch drive socket, ratchet
nuts (23)
handle, and 7/16-inch open-end wrench.
28
Clutch adapter (24)
Special washer (25)
Place in position.
and oil line (16)
2-1366
|
