|
| |
TM 5-2420-222-20-3
CLUTCH CONTROL VALVE-TO-HYDRAULIC PUMP INLET OIL LINE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
6. Hose (1)
Clamp (2)
a.
Place drain pan underneath.
b.
Using 1/4-inch flat-tip screwdriver,
loosen.
7. Hose (1), clamp (3)
Oil line (5)
a.
Place drain pan underneath.
and elbow (4)
b.
Using 1 1/2-inch open-end wrench,
screw off of elbow (14).
c.
Take out.
d.
Cap elbow(14).
e.
Tag (page 2-137).
8. Clutch control
Oil line (8) with
a.
Place drain pan underneath.
valve (6) and
assembled parts and
b.
Take out.
clamp (7)
packing (9)
c.
Get rid of packing (16).
d.
Get rid of drained oil (page 2-137).
e.
Plug valve(15).
f.
Tag oil line (8) page 2-137).
NOTE
Oil line mounting brackets and clamps support five oil lines. Do not remove
brackets or clamps unless inspection shows need for replacement.
9. Two clamps (3 and
Two screws (11),
a.
Using 1/2-inch, 1/2-inch drive
7) and two
lockwashers (12),
socket, ratchet handle, and 1/2-inch
brackets (10)
and nuts (13)
open-end wrench, unscrew and take
apart.
b.
Get rid of lockwashers (19).
10. Two brackets (10)
Two clamps
Take off.
and three oil lines
(3 and 7)
(14 thru 16)
11. Two brackets (10),
Two screws (19), and
a.
Using 9/16-inch, 1/2-inch drive
oil pan (17), and
lockwashers (20)
socket, 5-inch extension, and
engine block (18)
ratchet handle, unscrew and take out.
b.
Get rid of lockwashers (24).
12. Oil pan (17)
Two brackets (10)
Take off.
DISASSEMBLY
13. Hose (1)
Clamps (2 and 21)
Using 1/4-inch flat-tip screwdriver,
loosen.
2-1354
|
