|
| |
TM 5-2420-222-20-3
HYDRAULIC OIL FILTER RELIEF VALVE-TO-CLUTCH CONTROL VALVE ADAPTER OIL LINE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION
15. Elbow (1)
Hose (2) with two
a.
Uncap elbow (1).
assembled parts
b.
Take off tag.
c.
Place in position.
16. Clutch adapter (3)
Elbow (4) with
a.
Uncap clutch adapter (3).
assembled parts
b.
screw on and tighten using 1 1/2-
inch open-end wrench.
17.
Two clamps (5)
Using 1/4-inch open-end wrench, tighten.
18. Loader backhoe
Hydraulic oil filter
Install (page 2-1698).
19. Transmission
Check fluid level and add proper amount
and grade (TM 5-2420-222-10).
20. Engine
Start and run at high idle
(TM 5-2420-222-10).
21.
Hydraulic oil filter
a.
Check for leaks.
relief valve-to-
b.
If leaking at any connection, tighten
clutch control
using 1 1/2-inch open-end wrench and
valve adapter
1/4-inch flat-tip screwdriver.
oil line
c.
If leaking does not stop, shut down
engine (TM 5-2420-222-10) and
replace leaking oil line, hose,
fitting, or clamp as outlined in this
task.
d.
If found leaking, repeat steps 19
thru 21.
22.
Engine
If still running, shut down
(TM 5-2420-222-10).
2-1350
|
