|
| |
TM 5-2420-222-20-3
HYDRAULIC OIL FILTER RELIEF VALVE-TO-CLUTCH CONTROL VALVE ADAPTER OIL LINE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
DISASSEMBLY - CONTINUED
6. Elbow (1)
Oil line (2)
a.
Place elbow (1) in machinist’s vise.
b.
Note relative position for proper
placement during assembly.
c.
Using 1 1/2-inch open-end wrench,
unscrew and take off.
d.
Take elbow (1) out of machinist’s
vise.
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance
Instructions (page 2-137).
7.
Hose (3)
a.
Using clean rags dampened with solution
of detergent and water, wipe clean.
b.
Using clean water, rinse.
c.
Using clean, dry rags, wipe dry.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and
gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and
clothes and don’t breathe vapors. Do not use near open flame or excessive heat.
The flashpoint is 100°F to 138°F (38° to 59°C). If you become dizzy while using
cleaning solvent, get fresh air immediately and get medical aid. If contact with
eyes is made, wash your eyes with water and get medical aid immediately.
8.
All metal parts
a.
Clean in drycleaning solvent.
b.
Using clean, dry rags, wipe dry.
INSPECTION/REPLACEMENT
NOTE
For more information on how to inspect parts, go to General Maintenance
Instructions (page 2-137).
Replace defective parts as needed.
9.
Hose (3)
Look for cracks, breaks, and tears.
2-1348
|
