|
| |
TM 5-2420-222-20-2
RIGHT PLATFORM - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY
NOTE
Step 15 only applies to loader backhoes with Serial Numbers 319995 thru 342573.
Right platform has two pads. Both are assembled the same way. Front platform pad is shown. Repeat step 15
for remaining pad as needed.
15. Platform (1)
Pad (2)
a.
If removed, apply metal adhesive in
0.06 to 0.18-inch (1.52 to 4.57 mm)
wide beads, in 2.00-inch (50.8 mm) or
smaller squares.
Make sure that outside bead is within
0.25-inch (6.35 mm) of edge with no
gaps.
b.
Line up and press into place to transfer
some metal adhesive.
c.
Take off and allow metal adhesive to set
for two minutes.
d.
Line up and press firmly into place.
e.
Repeat step 15 for remaining pad.
INSTALLATION
16. Front cross member
Platform (1) with
Place in psoition.
(3), rear cross
assembled parts,
member (4), center
if present
platform support
(5), and center
platform (6)
17.
Platform (1) and
Two new lockwashers
Screw in part way.
center platform
(7) and screws (8)
support (5)
18.
Platform (1) and
Washer (9), new
If present, screw in and tighten using
front cross
lockwasher (10),
9/16-inch, 3/8-inch drive socket and
member (3)
and screw (11)
ratchet handle.
19.
Platform (1) and
Two screws (8)
Using 9/16-inch, 3/8-inch drive socket and
center platform
ratchet handle, tighten.
support (5)
2-1084
|
