|
| |
TM 5-2420-222-20-2
LEFT INNER PLATFORM RAMP - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSPECTION/REPLACEMENT
NOTE
For more information on how to inspect parts, go to General Maintenance Instructions (page 2-137).
Replace defective parts which cannot be repaired.
9.
Ramp (1)
Look for cracks, breaks, and abnormal
bends.
10.
Pad (2), if present
Look for cracks, tears, and crumbling.
11.
All ataching
Look for damaged threads.
hardware
ASSEMBLY
NOTE
Step 12 only applies to loader backhoes with Serial Numbers 319995 thru 342573.
12. Ramp (1)
Pad (2)
a.
If removed, apply metal adhesive in
0.06 to 0.18-inch (1.52 to 4.57 mm)
wide beads, in 2.00-inch (50.8 mm) or
smaller squares.
Make sure that outside bead is within
0.25-inch (6.35 mm) of edge with no
gaps.
b.
Line up and press into place to transfer
some metal adhesive.
c.
Take off and allow metal adhesive to
set for two minutes.
d.
Line up and press firmly into place.
INSTALLATION
13. Left outer platform
Clutch pedal (4)
Push down about 2 inches (50.8 mm) and
ramp (3)
hold.
2-1070
|
