|
| |
TM 5-2420-222-20-2
LEFT INNER PLATFORM RAMP - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
DISASSEMBLY
NOTE
Step 6 only applies to loader backhoes with Serial Numbers 319995 thru 342573.
WARNING
Water soluble cleaning compound solvent is flammable and fumes are toxic. Flashpoint is 2200F (1040C).
Boiling point is 212°F (1000C). Do not store in temperatures above 1500F (650C) or below 35°F (20C). Do not
use near open flame or excessive heat. Do not wear jewelry, wear rubber gloves and goggles, and use only in
well ventilated area. Avoid contact with skin, eyes, and clothes, and don't breathe vapors. Avoid contact with
acids, aluminum, or zinc; chemical reaction may result. If you become dizzy while using cleaning compound
solvent, get fresh air immediately and get medical aid. If contact with eyes is made, wash your eyes with water
and get medical aid immediately.
CAUTION
Left inner platform ramp pad may be destroyed when removed. Do not remove pad unless inspection shows
need for replacement, and pad replacement is available.
6. Ramp (1)
Pad (2)
a.
Note position for proper placement
during installation.
b.
Using clean rags and cleaning com-
pound solvent, dissolve adhesive.
c.
Using putty knife under edge, pull
up corner.
d.
Wet with more cleaning compound
solvent and continue to pull off.
e.
Repeat steps b thru d above until
completely removed.
f.
Using clean rag dampened with clean-
ing compound solvent, remove all
adhesive from ramp (1).
g.
Rinse ramp (1) and pad (2) with
clean water.
h.
Using clean, dry rags, wipe dry.
2-1068
|
