|
| |
TM 5-2420-222-20-2
STABILIZERS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION
WARNING
Some parts are heavy. Be careful when handling them. Lifting equipment is
needed when parts weigh over 50 pounds (23 kg) for a single person lift, over 100
pounds (45 kg) for a two person lift, and over 150 pounds (68 kg) for a three or
more person lift. Do not try to handle heavy parts without lifting equipment. Keep
clear of heavy parts supported only by lifting equipment. Failure to observe this
precaution could cause serious injury or death of personnel.
24.
Main frame (1)
Stabilizer (2) with
a.
With help of assistant, move cylinder
assembled parts
rod end (3) out of the way using 10-
ton capacity hydraulic dolly-type
jack, move and raise into position.
b.
Set cylinder rod end (3) down.
25.
Main frame (1) and
Main frame
a.
With help of assistant, aline holes
stabilizer (2)
stabilizer pin (4)
in main frame (1) and stabilizer (2).
b.
Using 3-pound head cross-peen
hammer and 3/4-inch brass-tipped
driftpin, tap into position.
26.
Stabilizer (2) and
Two washers (5)
Place in position.
main frame stabilizer
pin (4)
27.
Main frame stabi-
Two new cotter
a.
Place in position.
lizer pin (4) and
pins (6)
b.
Using multiple tongue and groove slip-
two washers (5)
joint pliers, bend ends back.
28.
Main frame (1)
Stabilizer (2))
Lower 10-ton capacity hydraulic dolly-
type jack and move out from underneath.
29.
Stabilizer (2)
Cylinder rod end (3)
Place in position.
2-1056
|
