|
| |
TM 5-2420-222-20-2
TIE ROD - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ADJUSTMENT - CONTINUED
47.
Two front wheels (1)
Two front hubs (3)
Using 50-foot measuring tape, measure
and front axle (2)
and record distances from ground.
48.
Two front hubs (3)
Two front
a.
Using 50-foot measuring tape and
and tires (4)
wheels (1)
marking crayon, mark inside front and
rear at same distances from ground as
measured in step 47.
b.
Using 50-foot measuring tape, measure
and record distances between both front
marks and both rear marks.
Distance between front of wheels
must be 118 to 318-inch (3.2 to
9.5 mm) less than distance between
rear of wheels.
NOTE
If measurement in step 48b is correct, skip steps 49 and 50.
49.
Tube (5) and
Two screws (7)
a.
On loader backhoes with Serial
two clamps (6)
nuts (8)
Numbers 235786 thru 235999, using
11/16-inch, 1/2-inch drive socket,
ratchet handle, and 518-inch box
wrench, loosen.
b.
On loader backhoes with Serial
Numbers 319995 thru 342573, using
3/4-inch, 1/2-inch drive socket,
ratchet handle, and 3/4-inch box
wrench, loosen.
50.
Two tie rod end
Tube (5)
a.
If difference in distance, noted in
sockets (9)
step 48b, was more than 3/8-inch
(9.5 mm), using 1/2 to 1 1/2-inch
adjustable pipe wrench, turn to
lengthen assembly and decrease
distance between front of wheels.
b.
If difference in distance, noted in
step 48b, was less than 1/8-inch
(3.2 mm), using 112 to 1 1/2-inch
adjustable pipe wrench, turn to
shorten assembly and increase distance
between front of wheels.
2-938
|
