|
| |
TM 5-2420-222-20-2
FRONT WHEEL BEARINGS AND HUBS
This task covers:
a.
Removal (page 2-914)
e.
Repair (page 2-918)
b.
Disassembly (page 2-916)
f.
Assembly (page 2-919)
c.
Cleaning (page 2-918)
g.
Installation (page 2-920)
d.
Inspection/Replacement (2-918)
h.
Adjustment (page 2-920)
INITIAL SETUP
Tools
Tools - Continued
Blocks, wood
NOTE
Chisel, cold, 1/2-inch
Driftpin, brass tipped, 3/4-inch
The following tool only applies
Extension, 1/2-inch drive, 10-inch
to loader backhoes with Serial
Hammer, ball-peen, 1-pound head
Numbers 319995 thru 342576.
Handle, ratchet, 1/4-inch drive
Handle, ratchet, 3/4-inch drive
Key, socket-head screw, 1/4-inch
Jack, dolly type, hydraulic,
10-ton capacity
Materials/Parts
Pliers, slip-joint
Puller, mechanical, gear and
Fitting, lubrication (item 10, Appendix C)
bearing, 5 1/2-inch reach
(as required)
Socket, 1/4-inch drive, 5/16-inch
Grease (LO 5-2420-222-12)
Socket, 1/2-inch drive, 7/8-inch
Pin, cotter
Socket, 3/4-inch drive, 1 1/2-inch
Rags, wiping (item 21, Appendix C)
Threading set, screw
Seal, plain encased
Trestle, motor vehicle, 5-ton
Solvent, drycleaning (item 28, Appendix C)
capacity, (two required)
Wrench, torque, 1/2-inch drive,
NOTE
0 to 175 foot-pound capacity
Wrench, torque, 3/4-inch drive,
The following part only applies
0 to 600 foot-pound capacity
to loader backhoes with Serial
Numbers 235786 thru 235999.
NOTE
Gasket, lub cap
The following tools only apply
to loader backhoes with Serial
Personnel Required
Numbers 235786 thru 235999.
One
Handle, ratchet, 1/2-inch drive
Knife, pocket
Socket, 112-inch drive, 5/16-inch
Socket, 112-inch drive, 1/2-inch
2-913
|
