|
| |
TM 5-2420-222-20-2
REAR TIRE AND WHEEL ASSEMBLIES - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
16.
Rim (1)
Reinforcing ring (2)
Place in position.
CAUTION
Screw holes in rear axle shaft, reinforcing ring, and threads on capscrews must be free of dirt,
grease, and oil or screws may not hold torque.
17.
Rim (1), rear axle
Eight washers (4)
a.
If necessary, using 26-inch pinch bar,
shaft (3), and
and screws (5)
aline screw holes.
reinforcing ring (2)
b.
Screw in and tighten until snug using
13/16-inch, 1/2-inch drive socket,
10-inch extension, and ratchet handle.
CAUTION
Screw holes in rear axle shaft and threads on capscrews must be free of dirt, grease, and oil or
screws may not hold torque.
NOTE
Step 18 only applies to loader backhoes with Serial Numbers 319995 thru 342573.
18.
Wheel (6) and rear
Eight washers (7)
a.
If necessary, using 26-inch pinch bar,
axle shaft (3)
and screws (8)
aline screw holes.
b.
Screw in and tighten until snug using
1 1/8-inch, 3/4-inch drive socket,
8-inch extension, and ratchet handle.
19.
Rear axle
Rear axle shaft (3)
a.
Using 10-ton capacity hydraulic dolly
housing (9)
type jack at housing (9), lift off of
5-ton capacity motor vehicle trestle.
b.
Take 5-ton capacity motor vehicle
trestle out from underneath.
c.
Using 10-ton capacity hydraulic dolly
type jack, lower just enough to keep
wheel (6) or rim (1) with assembled
tire (10) from rotating.
2-910
|
