|
| |
TM 5-2420-222-20-2
SERVICE BRAKE SPECIAL SCREW (BLEEDER)
This task covers:
a.
Removal (page 2-876)
c.
Inspection/Replacement (page 2-877)
b.
Cleaning (page 2-876)
d.
Installation (page 2-878) _
INITIAL SETUP
Tools
Materials/Parts - Continued
Pan, drain
Rags, wiping (item 21, Appendix C)
Wrench, box, 3/8-inch
Solvent, drycleaning (item 28, Appendix C)
Wire, non-electrical (item 35, Appendix C)
Materials/Parts
Personnel Required
Detergent, GP (item 7, Appendix C)
One
ACTION
LOCATION
ITEM
REMARKS
NOTE
There are two service brake special screws (bleeders). Left side is shown. Repeat procedures for right
side as needed.
REMOVAL
1.
Special screw (1)
Brake cap (2)
Pull off.
2.
Left axle
Special screw (1)
a.
Place drain pan underneath to catch
housing (3)
draining fluid.
b.
Using 3/8-inch box wrench, unscrew
and take out.
c.
Get rid of drained fluid (page 2-137).
d.
Cap housing (3) (page 2-137).
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-137).
3.
Brake cap (2)
a.
Clean in solution of detergent and
water.
b.
Using clean water, rinse.
c.
Using clean, dry rags, wipe dry.
2-876
|
