|
| |
TM 5-2420-222-20-2
MAIN AND FRONT LIGHT WIRING HARNESS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
106. Screw (1),
Terminal (4)
Push in between lockwasher (2) and
lockwasher (2),
washer (4).
and washer (3)
107. Fuel gage
Screw (1)
Using 1/4-inch flat-tip screwdriver,
sender (5) and
tighten.
terminal (4)
108. Connector (6)
Hydraulic pump
a.
Plug in.
solenoid lead
b.
Take off tag.
connector (7)
109. Main wiring harness
New plastic
a.
Put into place as noted during removal.
(8 or 9) except for
bands (10)
b.
Using slip-joint pliers, pull tight.
branch that goes
into cowl
110. Cowl (11)
Main wiring harness
Route branch that goes into cowl (11)
(8 or 9)
into place as noted during removal.
111. Circuit breaker
Terminal (13)
a.
Put on.
terminal (12)
b.
Take off tag.
112. Circuit breaker
New lockwasher (14)
Screw on and tighten using 3/8-inch box
terminal (12)
and nut (15)
wrench.
and terminal (13)
NOTE
Steps 113 thru 115 only apply to loader backhoes with Serial Numbers 235786 thru 235999.
113. Circuit breaker
Terminal (16)
a.
Put on.
terminal (12)
b.
Takeoff tag.
114. Circuit breaker
New lockwasher (17)
Screw on and tighten using 3/8-inch box
terminal (12)
and nut (18)
wrench.
and terminal (16)
115. Circuit breaker
Terminal (19)
a.
Put on.
terminal (12)
b.
Take off tag.
2-798
|
