TM 5-2420-222-20-2 MAIN AND FRONT LIGHT WIRING HARNESS - CONTINUED ACTION LOCATION ITEM REMARKS REMOVAL - CONTINUED 34. Circuit breaker Nut (3) and a. Using 3/8-inch box wrench, unscrew terminal (1) and lockwasher (4) and take off. terminal (2) b. Get rid of lockwasher (4). 35. Circuit breaker Terminal (2) a. Tag (page 2-137). terminal (1) b. Take off. 36. Circuit breaker Nut (6) and a. Using 3/8-inch box wrench, unscrew terminal (1) and lockwasher (7) and take off. terminal (5) b. Get rid of lockwasher (7). 37. Circuit breaker Terminal (5) Take off. terminal (1) 38. Cowl (8) Main wiring harness a. Note routing of branch that goes into (9 or 10) cowl (8) for proper placement during installation. b. Take out. 39. Main wiring harness Plastic bands (11) a. Note number and location for proper (9 or 10) placement during installation. b. Using diagonal-cutting pliers, cut off. c. Get rid of. 40. Connector(12) Hydraulic pump a. Tag (page 2-137). solenoid lead b. Unplug. connector (13) 41. Fuel gage Screw (16), Using 1/4-inch flat-tip screwdriver, sender (14) and lockwasher (17), loosen. terminal (15) and washer (18) 42. Screw (16), Terminal (15) Take out. lockwasher (17), and washer (18) 43. Voltage regulator Connector (20) a. Tag (page 2-137). connector (19) b. Using 3/16-inch flat-tip screwdriver, lift up tab on connector (19). c. Unplug. 2-782