|
| |
TM 5-2420-222-20-2
MAIN AND FRONT LIGHT WIRING HARNESS
This task covers:
a. Removal (page 2-775)
d. Repair(page 2-792)
b. Cleaning (page 2-790)
e.
Installation (page 2-792)
c. Inspection/Replacement (page 2-791)
INITIAL SETUP:
Tools
Materials/Parts - Continued
Handle, ratchet, 1/4-inch drive
Rags, wiping (item 21, Appendix C)
Handle, ratchet, 3/8-inch drive
Solvent, drycleaning (item 28, Appendix C)
Pliers, diagonal-cutting
Tags, marking (item 30, Appendix C)
Pliers, slip-joint
Screwdriver, flat-tip, 1/8-inch
NOTE
Screwdriver, flat-tip, 1/4-inch
Screwdriver, flat-tip, 3/16-inch
The following part only applies to
Socket, 1/4-inch drive, 11/32-inch
loader backhoes with Serial Numbers
Socket, 3/8-inch drive, 7/16-inch
235786 thru 235999.
Socket, 3/8-inch drive, 11/16-inch
Wrench, box, 11/32-inch
Lockwasher, circuit breaker terminal nut
Wrench, box, 3/8-inch
(eight required)
Wrench, box, 7/16-inch
Wrench, box, 9/16-inch
NOTE
Wrench, box, 11/16-inch
The following part only applies to
Materials/Parts
to loader backhoes with Serial Numbers
31995 thru 342573.
Band, plastic, electrical tiedown
(as required)
Lockwasher, circuit breaker terminal nut
Cleaning compound, solvent
(six required)
(item 4, Appendix C)
Detergent, GP (item 7, Appendix C)
Personnel Required
Lockwasher, ac generator terminal
nut
One
Lockwasher, ignition switch terminal
nut (five required)
Equipment Condition
Lockwasher, starter solenoid battery
terminal nut
1.
Battery ground cable disconnected
Lockwasher, starter solenoid terminal
(page 2-696)
nut
2.
Right side grille removed
Lockwasher, wire clamp nut
(TM 5-2420-222-10)
(two required)
3.
Cowl front cover removed (page 2-1020)
Lockwasher, wire clamp screw
4.
Loader control box door removed
Lockwasher, wire clamp screw nut
(page 2-1167)
Nut, self-locking, metering pump
5.
Right platform removed (page 2-1079)
shutoff solenoid
6.
Right inner platform ramp removed
(page 2-1095)
2-774
|
