|
| |
TM 5-2420-222-20-2
STOPLIGHT WIRING HARNESS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
32. Fender brace (1)
Stoplight wiring
Push through from bottom until 11 inches
harness (2)
(28 cm) past fender brace (1) using
78 3/4-inch measuring tape.
33. Fender (3)
Clip (4)
Put on.
34. Clip (4)
Stoplight wiring
Put in.
harness (2)
NOTE
Steps 35 thru 37 only apply to loader backhoes with Serial Numbers 319995 thru
342573.
35. Clip (4)
Lead (5)
Put in.
36. Connector (6)
Connector (7)
a.
Push on.
b.
Take off tag.
37. Connector (7)
Connector (8)
a.
Plug in.
b.
Take off tag.
NOTE
Steps 38 thru 40 only apply to loader backhoes with Serial Numbers 235786 thru
235999.
38. Two connectors
Double
Push on.
(9 and 10)
connector (11)
Leave on tags through step 39.
39. Double
Connector (12)
a.
Plug in.
connector (11)
b.
Take off tag.
40. Two connectors
Double
Take off tags.
(9 and 10)
connector (11)
41. Loader control
Stoplight wiring
Route into place as noted during removal.
box (13)
harness (2)
42. Ignition switch
Terminal (15)
Put on.
ACC terminal (14)
43. Ignition switch
New lockwasher (16)
Screw on and tighten using 3/8-inch box
ACC terminal (14)
and nut (17)
wrench.
and terminal (15)
44. Stoplight wiring
Plastic bands (18)
a.
Put on same number in same location
harness (2) and
as noted during removal.
loader backhoe
b.
Using slip-joint pliers, pull tight.
2-760
|
