|
| |
TM 5-2420-222-20-2
STOPLIGHT WIRING HARNESS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
13.
Left brake
Connector (2)
a.
Tag (page 2-137).
light pressure
b.
Pull off.
switch two
terminals (1)
14.
Right brake
Connector (4)
a.
Tag (page 2-137).
light pressure
b.
Pull off.
switch two
terminals (3)
15.
Clamp (5)
Screw (6),
a.
Using 11/16-inch box wrench, 11/16-
nut (7), and
inch, 3/8-inch drive socket, and
lockwasher (8)
ratchet handle, unscrew and take out.
b.
Get rid of lockwasher (8).
16.
Stoplight wiring
Clamp (5)
Take off.
harness (9)
17.
Loader backhoe
Stoplight wiring
Note routing for proper placement during
harness (9)
installation and take out.
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-137).
WARNING
Electrical parts solvent cleaning compound (trichlorotrifluoroethane) is flammable,
and reacts violently with aluminum, titanium, barium, lithium, samarium, and
sodium potassium. Cleaning compound fumes displace air and it may be
carcinogenic. Boiling point is 1140F (460C). Do not wear jewelry. Wear rubber
gloves and use only in well ventilated area. Avoid contact with skin, eyes, and
clothes and do not breathe vapors. Do not use near open flame or excessive heat.
If you become dizzy while using cleaning compound, get fresh air immediately and
get medical aid. If contact with eyes is made, wash your eyes with water and get
medical aid immediately.
18.
Stoplight wiring
a.
Using clean rag dampened with solvent
harness (9)
cleaning compound, wipe clean.
b.
Dip connectors in solvent cleaning
compound.
b.
Using clean, dry rags, wipe dry.
2-756
|
