|
| |
TM 5-2420-222-20-2
REAR LIGHT WIRING HARNESSES - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
NOTE
Steps 4 thru 6 only apply to loader backhoes with Serial Numbers 319995 thru 342573.
4.
Connector (1)
Connector (2)
a.
Tag (page 2-137).
b.
Unplug.
5.
Connector (3)
Connector (4)
a.
Tag (page 2-137).
b.
Unplug.
6.
Connector (5)
Connector (6)
a.
Tag (page 2-137).
b.
Using 1/8-inch flat-tip screwdriver,
lift tab on connector (5).
c.
Unplug.
7.
Fender (7) and
Clip (9)
Using 1/8-inch flat-tip screwdriver,
rear light wiring
pry open.
harness (8)
8.
Clip (9)
Rear light wiring
Take out.
harness (8)
9.
Rear light wiring
Three connectors
a.
Using duct tape, tape into smallest
harness (8)
(10, 11, and 12) or
diameter bundle possible.
four connectors
Bundled connectors must be able to
(2, 3, 6, and 13)
pass between fender and braces.
b.
Tie on 7 feet (2.13 m) of lacing and
tying tape.
10.
Fender (7)
Rear light wiring
Pull out through fender and braces from
harness (8)
front.
Leave lacing and tying tape between
fender and braces to aid in installa-
tion, step 19.
11.
Rear light wiring
Three connectors
a.
Untie and take off lacing and tying
harness (8)
(10, 11, and 12) or tape.
four connectors
b.
Take off duct tape.
(2, 3, 6, and 13)
2-740
|
