|
| |
TM 5-2420-222-20-2
REAR LIGHT WIRING HARNESSES
This task covers:
a.
Removal (page 2-738)
d.
Repair (page 2-742)
b.
Cleaning (page 2-742)
e.
Installation (page 2-743)
c.
Inspection/Replacement (page 2-742)
INITIAL SETUP
Tools
Personnel Required
Screwdriver, flat-tip, 1/8-inch
One
Materials/Parts
Equipment Condition
Cleaning compound, solvent
Battery ground cable disconnected
(item 4, Appendix C)
(page 2-696)
Rags, wiping (item 21, Appendix C)
Tags, marking (item 30, Appendix C)
Tape, duct (item 31, Appendix C)
Tape, lacing and tying
(item 33, Appendix C)
ACTION
LOCATION
ITEM
REMARKS
NOTE
Both rear light wiring harnesses are maintained the same way. One side is shown.
Repeat procedures for other side as needed.
REMOVAL
1.
Connector (1)
Connector (2)
a.
Tag (page 2-137).
b.
Lift tab on connector (1).
c.
Unplug.
NOTE
Steps 2 and 3 only apply to loader backhoes with Serial Numbers 235786 thru
235999.
2.
Connector (3)
Connector (4)
a.
Tag (page 2-137).
b.
Unplug.
3.
Connector (5)
Connector (6)
a.
Tag (page 2-137).
b.
Unplug.
2-738
|
